Shield Auto Parts

Tag Archives: OMP

Planted PSP.25 Seat Spacer – 1/4 inch Thick Black Powder Coated Aluminum

Posted on by Posted in Planted Seat Brackets, Seat Spacers

Planted PSP.25 Seat Spacer

Planted Seat Spacer – 1/4 inch Thick – Black Powder Coated Aluminum – Part # PSP.25

This Planted Seat Spacer is 1/4 inch thick aluminum powder coated black, and is the length and width of the Recaro Non-tabbed slider. The spacer weighs about 1 lbs total and includes pre-drilled slots so putting them between the slider and the seat bracket is a sinch with some longer hardware. Planted created these spacers to solve an issue with the Recaro Sportster CS, Style, Sport, and Trend seats where the bottom of the seat hangs down lower than the sliders making contact with the bracket. Raising them 1/4 inch solves the issue.
The spacers are also ideal for raising any seat that sits lower then desired and can be used with other major brands of sliders like Sparco & OMP. They can also be used without sliders although in some cases drilling additional holes may be required.

The seat spacer is sold in a pair (enough for one seat).

Measurements: 
Length = 15-1/2 inches
Width = 1-1/2 inches
Hole Spacing = 12-1/4 inches to 13-11/16 inches (both holes are slotted)


Made in USA Logo Planted Technology




Color / Finish: Black Powder Coated Aluminum
Quantity: 1 Pair (enough for 1 seat)
Vehicle Placement: Universal (Fits either side)
Manufacturer: Planted Technology


Find yours today via our eBay store


Shield Auto Parts Steering Wheel / Quick Release Spacer for NRG Short Quick Release

Posted on by Posted in Steering Wheel Spacers

Shield Auto Parts Spacer

Shield Auto Parts – 12mm Spacer for MOMO, NRG, Sparco, and OMP Steering Wheels + Snap Off and NRG Short/Thin Quick Releases

The Shield Auto Parts Spacer is made of 6061-T6 Aluminum in a Black Textured Powder Coating and is 12mm (0.47 inches) tall. 

To those of you who have wanted to install an NRG Short Quick Release on an NRG Short Hub Adapter, only to find out that the quick release bottoms out on the column nut or that the NRG Spacer is too wide to fit the short quick release, here is your answer. The Shield Auto Parts Spacer is is short enough to not cause the steering wheel to be pushed too close but tall enough to clear the base on the on the NRG Short Quick Releases (please note for vehicles that have a longer column that protrudes past the NRG short hub adapter, an additional spacer may be required).

Includes (6) 25mm Countersunk Screws for use on most steering wheels and Snap Off Quick Releases. 
Includes (6) 30mm Socket Cap Screws for use with NRG Short Quick Releases

Please Note: NRG Standard Quick Releases/Steering Wheels (if using trim ring) use Button Head Screws (sold separately).

The inner diameter of the spacer is large enough to use a MOMO Retainer Ring where needed. For NRG Steering Wheels, 30mm button head screws (for NRG) would be required for this spacer (available separately) unless using the NRG Steering Wheel without their trim ring.

For use with 6 hole Quick Releases, Steering Wheels, and Hub Adapters that use a 70mm bolt pattern. Will NOT fit Nardi, Personal, or Dino that use the 74mm bolt pattern


Find yours today via our eBay store